Cartographic Projection
every map is wrong, and by exactly how much
Figure

What changing the datum alone does to a coordinate

Drawn here at the parameters it defaults to, with every essay that calls it.
What changing the datum alone does to a coordinate. The distance on the ground between a point as read on its national datum and the same numbers read on WGS84, computed through the published seven-parameter transformation. The shifts run from 49 to 166 metres. For comparison, the scale error a UTM zone introduces at its edge is under a metre per kilometre — so the datum, which is usually left unstated, dominates the projection, which is usually argued about.

The distance on the ground between a point as read on its national datum and the same numbers read on WGS84, computed through the published seven-parameter transformation. The shifts run from 49 to 166 metres. For comparison, the scale error a UTM zone introduces at its edge is under a metre per kilometre — so the datum, which is usually left unstated, dominates the projection, which is usually argued about.

It is drawn by ellipsoid-figure with show: "datum-shifts" — one member of a family of 12 figures that share a generator, so the drawing above is what that generator returns when it is asked for this one and given nothing else.

9 essays call it. Every call below passes it something, because a placement that passes nothing draws whichever member of the family the generator happens to default to rather than the one its essay argues about.

Where it is called

Changing this changes every one of these figures.

The same coordinate on four datums. One pair of numbers — 2.0° west, 54.5° north — read as a coordinate on OSGB36, ED50, NAD27 and on WGS84, and plotted where each reading puts the mark on the ground. The spread runs to 195 metres. The numbers are identical; only what they refer to differs. What the numbers refer to

What a coordinate refers to

A latitude and a longitude are not a place. They are a claim about a model, and the model has a shape, a position, a set of marked stones and a date — change any one of the four and the ground under the numbers moves by hundreds of metres.

 OSGB36 to WGS84, one parameter at a time. Each bar is how far the mark at 2.0° west, 54.5° north moves under one of the seven parameters with the other six set to zero. seven of the seven are not zero for OSGB36. The units hide the comparison: one arcsecond of rotation moves this point 30.8 metres and one part per million of scale moves it 6.36 metres, so OSGB36's scale term contributes 130 metres — more than one of its three translations. What the numbers refer to

The seven parameters, and what each one does

A datum transformation is published as three metres, three arcseconds and one part per million, in three different units — which hides the fact that all seven are the same size of thing. Converted to ground displacement, the scale term beats two of the translations.

 Why there are two latitudes, at 45°. A meridian section of an ellipsoid with the flattening exaggerated 12× — at the true value of 1/298 this outline would be indistinguishable from a circle. Geodetic latitude is the angle the surface normal makes with the equatorial plane; geocentric latitude is the angle the radius makes with it. The two lines meet the plane at different points and the angles differ by 11.55 arcminutes on the real WGS84 ellipsoid, which is about 21 km of ground distance. What is taught wrongly

The Earth is a sphere, and when it is not

Every essay before this one treated the Earth as a ball, and said so. The flattening is one part in three hundred, which is nothing for a distance, everything for a latitude, and exactly enough to make the most-used projection in the world fail the property in its own name.

 What 4 parts per million of network strain leaves behind. Each arrow is where the best-fitting seven-parameter transformation leaves a marker, over 36 markers laid out as a grid across OSGB36's ground. The RMS residual is 1.64 metres and the worst is 3.00 metres. Seven parameters span the constant and linear parts of a displacement field; this one is quadratic, so no choice of the seven can reach it. The arrows are drawn 27× life size. What the numbers refer to

Where a fit leaves residuals

Seven parameters can carry a rigid motion and a size exactly. A triangulation network is neither, so the best possible transformation between two datums leaves metres on the table — in a pattern, not as noise — and which seven parameters come out depends on where the markers were.

 The sixty zones, each six degrees wide. Every zone is a separate transverse Mercator projection about its own central meridian, so the world is covered by sixty maps rather than one. Zone 31 is picked out, running from 0° to 6° with its axis on 3°. Coordinates do not carry across a zone boundary — a point on either side of one has two entirely different eastings, and nothing in the numbers says which zone they belong to. The families

UTM and the zone system

Sixty separate maps of the world, each six degrees wide, each with a scale factor of 0.9996 chosen so the projection is wrong everywhere and less wrong at the edges. Every constant in the definition is a measured trade rather than a convention.

 Five latitudes that are not the latitude, on WGS84. Each curve is the amount by which one auxiliary latitude falls below the geodetic latitude a coordinate actually means, in arcminutes. All five vanish at the equator and at the poles and peak near 45°, where the geocentric latitude is 11.55 arcminutes below the geodetic one — about 21.4 km on the ground. The curves never cross, which is forced by the algebra rather than by this ellipsoid's particular flattening. What is taught wrongly

Geodetic against geocentric latitude

Two angles, both called latitude, differing by eleven and a half arcminutes at their worst. One is what every coordinate means and the other is what every spherical formula assumes, and the gap between them is twenty-one kilometres on the ground.

 What changing the datum alone does to a coordinate. The distance on the ground between a point as read on its national datum and the same numbers read on WGS84, computed through the published seven-parameter transformation. The shifts run from 49 to 166 metres. For comparison, the scale error a UTM zone introduces at its edge is under a metre per kilometre — so the datum, which is usually left unstated, dominates the projection, which is usually argued about. What is taught wrongly

Datum shifts dwarf projection errors

The projection argument is conducted in parts per million and the datum question is answered in hundreds of metres. A coordinate whose datum is unstated is out by more than any projection choice could ever put it, and almost nobody checks.

 A transformation is more certain in some places than others. The horizontal position uncertainty a Helmert transformation carries, from the stated widths of its own seven parameters, along three meridians. It runs from 40 mm to 68 mm — a factor of 1.71 — and it falls towards the poles, because the rotation terms act on the distance from the Earth's axis. A single figure quoted for "the accuracy of the transformation" is the value at some latitude nobody wrote down. What the numbers refer to

The seven parameters have their own uncertainty

Nine essays on this ladder print a datum transformation as seven exact numbers. Every published set is the output of a least-squares fit and arrives with standard errors as much a part of the result as the parameters — and pushing those widths through to the ground gives an ellipse, not a number, that is 68 mm across at the equator and 43 mm at 70°.

 What reading the seven parameters under the wrong convention costs. The distance between the two published conventions' answers for the same parameter set, at the worst point of the world. The difference is 2s(r × X) exactly — twice the rotation, crossed into the position — so a parameter set with no rotations is immune and one with a large rotation is not: DHDN reaches 152.3 metres and NAD27, whose published transformation is three translations and nothing else, reaches zero. The note beside each bar is the size of that datum's rotation. What the numbers refer to

The rotation has two sign conventions

Eleven essays price a datum transformation's parameters, their fit, their residuals and their uncertainty. None asks what the numbers mean: three of the seven are published under two conventions whose rotations differ in sign, and reading one set with the other formula costs exactly twice the rotation — 55 metres on OSGB36 and 152 on DHDN.

The whole library