Concept

Isometric coordinate — where it appears

A coordinate in which the sphere's own metric is a scalar multiple of the flat one, so that a conformal map is an analytic function of it. Every conformal projection of the sphere is an analytic function of it, which is what turns a projection problem into a complex-analysis one.

Named by 3 essays across 3 fields — each of them below, with the objects they name alongside it.

Six projections, at 40° north. Flexion (solid) and skewness (light) against direction of travel, drawn about a zero circle at one point of each projection. The three conformal ones have curves of exactly equal size, offset by exactly 90°, because on a conformal map both quantities are components of one vector — the gradient of the log of the scale. The others have neither property: ratios run from 0.72 to 2.72.

Bending and stretching are one failure

The ladder was written expecting flexion and skewness to be two independent ways for a map to be wrong. On a conformal projection they are not independent at all: the two extremes are the same size to four figures and sit exactly ninety degrees apart, because both are components of a single vector.

distortion · Flexion

The minimum-distortion conformal map of an elongated region, 30° by 10°. The conformal projection of an elongated region, 30° by 10° whose scale is constant on the boundary, which is Chebyshev's criterion, obtained by fitting eight terms of a series rather than by choosing a named projection. The scale factor runs from 0.98640 to 1.00000, a spread of 1.01379; on the boundary itself the largest departure from constancy is 2.13e-7 in the log, which is what the fit achieved and not what it was told. Each dot is an interior sample shaded by its own departure from the boundary's scale.

Solving for the map instead of choosing it

Chebyshev's criterion has sat on this site since its second phase with one case it could be applied to: the spherical cap, whose answer is the stereographic projection. For any other region the site stated the criterion and stopped. It is a linear least-squares fit, and the fitted map beats every named projection over the region it was fitted to.

choosing · Condition

The conformal map onto a square face of a cube. The spherical face of a cube carried onto its flat face by a map that is conformal everywhere — the measured angular deformation over the drawn interior is 1.63e-6°, which is the arithmetic's own floor. The rings and spokes are circles and radii on the sphere, and they cross at right angles here because that is what conformal means. The map was solved for as 16 terms of a series rather than written down: the face's edge comes out straight to 0.33 per cent of its own half-width, and that residual — not the conformality — is what more terms buy. At each corner the map behaves like ζ^0.75, so the scale factor there is infinite.

A conformal map onto a face

The polyhedral ladder ended owing a conformal face map, on the grounds that it needs elliptic functions. It does not: a conformal map of the sphere is an analytic function of one conformal coordinate, so the map is a power series, choosing it is a least-squares fit — and its scale factor is infinite at the corners, which is the angle deficit arriving as a singularity.

families · Polyhedral

Named alongside it

The objects these essays reach for when they reach for this one.

Conformality Closed form Least-squares Series truncation Angle deficit Azimuthal Boundary-value Branch cut Chebyshev's bound Chebyshev's criterion Constraint Convergence rate

All concepts